AgriInfo.in
AgronomyHorticultureBotanySoil SciencePlant PathologyEntomologyExtentionAgril. EngineeringDairy ScienceEconomics
 
categories
 
» Livestock Production and Management
» Practicals on Technology of Milk & Milk Products
agriculture information

Current Category » Livestock Production and Management

Loose housing system

Loose housing maybe defined as a system where animals are kept loose except milking and at the time of treatment. The system is most economical. Some features of loose housing system are as follows.

  1. Cost of construction is significantly lower than conventional type.

  2. It is possible to make further expansion without much change.

  3. Facilitate easy detection of animals in heat

  4. Animals feel free and therefore, prove more profitable with even minimum grazing.

  5. Animals get optimum exercise which is extremely important for better health and production

  6. Overall better management can be rendered.

 

The floor and manger space requirement of dairy cows are give in Table below

Other provisions:

The animal sheds should have proper facilities for milking barns, calf pens/ calving pens and arrangement for store rooms etc. In each shed, there should be arrangement for feeding, manger, drinking area and loafing area.

The shed may be cemented or brick paved, but in any case it should be easy to clean. The floor should be rough, so that animals will not slip. "The drains in the shed should be shallow and preferably covered with removable tiles. The drain should have a gradient of 1" for every 10' length. The roof may be of corrugated cement sheet, asbestos or brick and rafters. Cement concrete roofing are too expensive.

Inside the open unpaved area it is always desirable to plant some good shady trees for excellent protection against direct cold winds in winter and to keep cool in summer.

Table:


Type of Animal

Floor space per animal ( Sq. feet)

Manger length per animal ( inches)

Covered Area

Open Area

Cows

20 – 30

80 – 100

20-24

Buffaloes

25-35

80-100

24 -30

Young stock

15-20

50-60

15 -20

Pregnant Cows

100-120

180 – 200

24 -30

Bulls Pen

120-140

200-250

24 -30

Cattle shed:

The entire shed should be surrounded by a boundary wall of 5' height from three sides and manger etc., on one side. The feeding area should be provided with 2 to 2 % feet of manger space per cow. All along the manger/ there shall be 10" wide water through to provide clean, even, available drinking water. The water trough thus constructed will also minimize the loss of fodders during feeding. Near the manger, under the roofed house 5' wide floor should be paved with bricks having a little slope. Beyond that, there should be open unpaved area (40' X 35') surrounded by 5' walls with one gate. A plan for such a house along with the plan for calves shed and their sections are shown in Fig, 105, it is preferable that animals face north when they are eating fodder under the shade. During cold wind in winter the animals will automatically lie down to have the protection from the walls.

Shed for calves: On one side of the main cattle shed there shall be full covered shed 10' X 15' to accommodate young calves. Such sheds with suitable partitioning, may also serve as calving pen under adverse climatic conditions. Beyond this covered area there should be a 20' X 10' open area having boundary wall so that calves may move there freely.

In this way both cattle and calve sheds will need in all 50 X 50 area for 20 adult cows and followers. If one has limited resources, he can build ordinary, katcha /semi Kutcha boundary walls but feeding and water trough should be cemented ones.

Current Category » Livestock Production and Management